Combustion Controls And Accessories

Programmer For Micro-M Series Controls. Relight Operation With 10 Second PTFI.

Programmer For Micro-M Series Controls. Selectable Purge Timing PTFI Timing Recycle/Non-Recycle Post Purge Prove Air Open At Start.

Micro M Program Run-Ck Switch * Programmer For Micro-M Series Controls. Same As MeP230H But Has 10 Second MTFI &A Check/Run Switch.

AMP .8

Amplifier For Micro-M Series Controller. Rectification. 3 Second FFRT.

Amplifier For Micro-M Series Controller. Ultraviolet. 0.8 FFRT.

Amplifier For Micro-M Series Controller. Ultraviolet 3 Second FFRT.

Micro M U.v.self-check Amplif.

Programmer Module For Fireye Modular M-Series Ii Controls. Continuous Re-Light Operation.

Programmer Module For Fireye Modular M-Series Ii Controls. Selectable Dip- Switches For Purge Timing Pilot Trial For Ignition Timing And Recycle Or Non-Recycle Operation.

Programmer Module For Fireye Modular M-Series Ii Controls. Selectable Purge And PTFI Timing Pilot Stabilizing And Recycle/Non-Recycle Operation. 10 Sec. Main Flame TFI. Has A Check-Run Switch.

2-Gas Novo Pro Portable Combustion Analyzer Kit w/ built in printer. Seven inch touch display, long life o2 sensor, differential pressure manometer, O2, CO, C02, Efficiency, Excess Air,Draft, Pressure, Temp, rechargeable Li-Ion batteries, integrated water trap, simultaneous gas pressure & combustion measurements, calculations for high efficiency & condensing systems, 12" probe w/ 6" hose, hard plastic carrying case & Real-Time Bluetooth Apps (iOS and Android. 4 yr warrenty on oxygen sensor. 2 Yr on everything else

4" HAT BRACKET for Fireye NX and PPC actuators

Infrared amplifier for NXF4000.

Ultraviolet amplifier for NXF4000 parallel positioning controllers.

VFD Internal Board for PPC4000 * PPC4000 interface board to allow VFD control of blower motors.

8 mm X 10 mm Coupler. fits FX04 to Eclipse butterly valves.

Gas Valve Coupling for FX04 actuators. 8MM "D" shaft x 1/2".

8MM TO 1/4 SHAFT COUPLING

NXC20 or FX20 X 3/4 Coupling

Grenwood 12MM X 3/8 Coupler for FX20 to 3/8" shaft.

Coupling 12MM X 1/2 Inch

12MM X 5/16" Coupler for FX20 to 5/16" shaft.

12MM X 5/8" COUPLER